Thursday, October 11, 2012

Oiling Older Internal Gear Hubs Like Sturmey Archer AW

Older internal gear hubs like Sturmey Archer AW hubs (the most common) use oil rather than grease to lubricate internal parts. These hubs can be identified by their large diameter and the presence of an oil filler cap. The hub in the picture below is a prime example: it is an AW. That black rubber dot you see on the wheel's hub is a cap that opens and allows you to put in oil.


The question that follows is, "what sort of oil do I use?". The answer is both simple and tricky. The original service manuals call for SAE 20 oil-- this is your basic petroleum-based oil of light weight. It is pure and does not contain detergents or vegetable derivatives. Sturmey Archer actually made and marketed their own oil, for the purist.

You should not use heavier substances like heavy gear oil, 50 weight motor oil, etc. You also should not use substances like WD40. WD40 is great for cleaning hubs filled with junk, but not for lubricating a ready hub. The one place you can use a little grease is on the hub bearings, assuming you want to take the hub apart (most avoid it).

So you can use SAE 20 motor oil from the auto parts store. I use SAE 20 because I tend to like sticking to the original spec stuff. However, I buy it in small, blue and white cans made by 3 in 1. It is called 3 in 1 "motor" or "electric motor" oil.




If you cannot find SAE 20 (whether motor oil or 3 in 1 blue label), you can get by with SAE 30 motor oil. It's a little heavier but will still do the job.

One substance that is advertised specifically for bicycles is 3 in 1 Standard Household oil. It comes in a black, red, and white can. The label is black, not blue. This oil tends to congeal in hubs and leave a nasty, sticky mess. If you want to use a 3 in 1 product, use the blue label "motor" oil shown above. I've heard of people using automatic transmission fluid and Phil Wood products as well, but have been perfectly content with SAE 20, so why mess with an original, working formula?

Today, most internal gear hubs rely on grease and do not involve oil filler caps. These hubs can be given a shot of life now and then by slipping some oil in the hollow side of the axle, but a full re-build means taking it apart and re-greasing. I tend to prefer the old ones, which require periodic oiling but rarely need to be opened up. 

As an interesting aside, Sturmey Archer hubs also have a 3 or 4 digit code on the shell, which lists the month and year the hub was made. The green on above says "5 74", or May 1974.


[Update, Feb. 2024: see my additional note on grease versus oil in vintage Sturmey Archer hubs, available HERE.]

1 comment:

Please keep comments on topic and civil. Comments subject to moderation.